Stereo PA amplifier with SMPS, 2 x 1250 W / 4 ohms
- Stereo PA amplifier with class D circuitry
- Low weight and height due to integrated switch mode power supply
- Reliable power amp with high impulse stability for a wide range of applications (e.g. compact PAs, multi-way PAs, concerts)
- Limiter and speaker switch-on delay
- 3 operating modes can be selected (stereo, parallel or bridged)
- 2 calibrated level controls for precise level adjustment
- Input sensitivity adjustable
- LED VU meter and LEDs for activated protective circuit (protect), overload (clip), and signal per channel
- Highly efficient front-to-rear air routing
- Electronically balanced inputs via XLR mounting jacks, with XLR feed-through outputs
- Speaker outputs via lockable Speaker plugs and screw terminals
- Rugged steel chassis with aluminum front panel
- Rack installation with 2 units
- Housing design: (19" ) 48.3 cm rack installation 2 U
| Power supply: | 110-240 V AC, 50/60 Hz |
| Power consumption: | 200 W 1/8 power |
| Power/channel (4 Ohm): | 1250 W |
| Frequency range: | 20 - 20000 Hz |
| Power connection: | Mains input P-Con (blue), mounting version Power supply cord with safety plug (provided) |
| Number of channels: | 2 |
| Housing design: | (19" ) 48.3 cm rack installation 2 U |
| Width: | 48,3 cm |
| Height: | 8,9 cm |
| Depth: | 30,7 cm |
| Weight: | 6,25 kg |
| Power output (RMS): | |
| Stereo, parallel at 8 ohms | 2 x 700 W |
| 8 ohms bridged | 1 x 2500 W |
| Signal-to-Noise ratio: | > 100 dB |
| Total harmonic distortion: | < 0.15 % |
| Damping factor: | > 500 |
| Voltage gain: | 39.7 dB |
| Slew rate: | > 10 V/µ sec |
| Input sensitivity: | 0.775 V/1.0 V/1.81 V bzw. 39.3 dB/37 dB/32 dB, switchable |
| Input impedance: | 20 kohms (balanced), 10 kohms (unbalanced) |
| Input connectors: | 4 x XLR |
| Output connectors: | 4 x Speaker, 4 x XLR feed-through output |
| Circuitry: | Class D |
| Protection: | Softstart, short-circuit, overheat, overload, clip limit, RF and VHF signals |
| Cooling: | 2 temperature-controlled fans, front-to-rear |
| Controls: | Power switch, input attenuators, mode switch stereo/parallel/bridged, input sensitivity |
| LED indicators: | protect, clip, - 5 dB, - 10 dB, - 20 dB (per channel) |
| Construction: | steel chassis, aluminum front |
| Rack installation with 2 U |
Write Your Own Review
